Can my jet land there?
A charter flight has to land within 60% of the runway, not just fit on it. Pick an aircraft and an airport to see how the published figures compare under the commercial rules, before we confirm it with the operator.
Pick an aircraft and an airport to see how the runway compares under the commercial rules.
86 airports and 56 aircraft. 36 aircraft have a landing figure from the maker or a trade reference. This is a screen, not a performance calculation, and not for operational use.
How the check works
- The runway figures are the declared distances in each country's official AIP (aeronautical information publication): the landing distance available, and the take-off run and accelerate-stop distance available, for each runway direction. They are often shorter than the runway's length because of displaced thresholds and safety areas.
- The aircraft's landing figure is the maker's published, unfactored landing distance at sea level. We divide it by 0.6 for a jet or 0.7 for a turboprop, as the commercial rules require, and add 15% for a wet runway.
- “Fits with margin” needs 10% in hand when the maker quotes the figure at maximum landing weight, and 25% when it is quoted at a lighter or unstated weight, which most makers do. Less than that is “tight”; short of the rule is “doesn't meet the commercial rules”.
- Take-off compares the maker's published take-off distance at maximum weight with the shorter of the take-off run and accelerate-stop distance. A shorter runway doesn't rule a flight out: it means a lighter take-off, which the operator works out.
- Airports above 1,000 ft, airports whose figures don't come from the AIP, and airports where the aircraft or crew need special approval are never shown as comfortable. Our guide to airports that need special planning explains those approvals.
The rules are UK Regulation 965/2012, Annex IV: CAT.POL.A.230 (landing, dry runways), CAT.POL.A.235 (wet runways) and CAT.POL.A.205 (take-off), on legislation.gov.uk. Runway figures are re-checked each AIRAC cycle; each result shows the date.
Questions
What is the 60% landing rule for private jets?
Under the UK and EU rules for commercial flights, a jet must be able to land and stop within 60% of the runway's declared landing distance, from 50 ft above the threshold. A turboprop must stop within 70%. So a jet whose published landing distance is 750 m needs at least 1,250 m of landing distance available for a charter flight, even though it could physically stop in less.
Why does a private flight sometimes use a runway a charter flight can't?
Privately operated flights follow different performance rules from commercial ones. A charter flight is commercial air transport, so the operator must meet the 60% or 70% rule and the commercial take-off rules on every flight. That is why an aircraft seen at a small airfield can't always be chartered into it.
How much longer does a wet runway need?
15% more landing distance than the dry figure, unless the aircraft's flight manual gives its own wet-runway figures. Contaminated runways, with standing water, snow or ice, need more again, and the operator works that out on the day.
Why can a jet land somewhere but not take off fully loaded?
Take-off needs room to accelerate and, if an engine fails, either stop or climb away. At a short runway the operator may limit the take-off weight, which means less fuel or fewer passengers, or a fuel stop on the way. Height and heat make it worse because thinner air reduces engine thrust and lift.
Why doesn't the checker ever say yes?
Because the answer depends on things only the operator's performance calculation can settle: the actual weight, temperature, wind, runway slope, obstacles, approvals for that airport and the aircraft's own flight manual data. The checker screens out the combinations that can't work and flags the tight ones, and we confirm the rest for your flight.
Independent UK charter broker since 2015 · Volairis Ltd, Companies House 09488748 · Member of The Air Charter Association